Instruction Manual

Page 126
AFL2-W15B-H61
Step 1: Follow all anti-static procedures. See Section 7.2.
Step 2: Turn off the power. See Section
7.3.
Step 3: Remove the back cover. See Section
7.4.1 above.
Step 4: Remove the internal aluminum back cover. See Section
7.4.2 above.
Step 5: Locate the DDR3 SO-DIMM on the motherboard.
Step 6: Remove the DDR3 memory module by pulling both the spring retainer clips
outward from the socket.
Step 7: Grasp the DDR3 memory module by the edges and carefully pull it out of the
socket.
Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle
(
Figure 7-4).
Step 9: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 7-4).
Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 7-4: DDR SO-DIMM Module Installation
Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.