Owner's manual

AFL2-W15A-N270/L325 Panel PC
Page 23
2.7 Jumper Settings
NOTE:
A jumper is a metal bridge used to
close an electrical circuit. It consists of
two or three metal pins and a small
metal clip (often protected by a plastic
cover) that slides over the pins to
connect them. To CLOSE/SHORT a
jumper means connecting the pins of
the jumper with the plastic clip and to OPEN a jumper means removing
the plastic clip from a jumper.
The following jumpers can be found on the motherboard installed in the
AFL2-W15A-N270/L325. Before the AFL2-W15A-N270/L325 is installed, the jumpers
must be set in accordance with the desired configuration. The jumpers on the
AFL2-W15A-N270/L325 motherboard are listed in
Table 2-4.
Description Label Type
CF card setup JCF1 2-pin header
Clear CMOS J_CMOS1 3-pin header
COM1 Pin 9 setting JP5 10-pin header
COM3 Pin 9 setting JP7 6-pin header
COM3 RX RS-232/422/485 select JP8 8-pin header
COM3 RS-232/422/485 select JP10 12-pin header
COM3 TX RS-422/485 select JP11 6-pin header
Table 2-4: AFL2-W15A-N270 Jumpers