User Manual

AFL2-W10A-N28 Panel PC
Page 39
3.12 External Peripheral Device Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
 Audio devices
 HDMI devices
 RJ-45 Ethernet cable connector
 Serial port devices
 USB devices
 VGA monitor
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding AFL2-W10A-N28 external peripheral interface connector
making sure the pin s are properly aligned.
3.12.1 Audio Connection
The audio jack on the external audio connector enables the AFL2-W10A-N28 to be
connected to a stereo soun d setup. To install the audi o devices, follow the steps below.
Step 1: Identify the audio plugs. The plugs on your home theater system or speakers
may not match the colors on the rear panel. If audio plugs are plugged into the
wrong jacks, sound quality will be very bad.
Step 2: Plug the audio plug into the audio jack. Plug the audio plug into the audio
jack. If the plug on your speakers is diff erent, an adapter will need to be used to
plug them into the audio jack. The audio jack on the AFL2-W10A-N28 is a
line-out port which connects to a headphone or a sp eaker.