User Manual

AFL2-W10A-N28 Panel PC
Page 30
3.11.2 Panel Mounting
To mount the AFL2-W10A-N28 flat bezel panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the pan el to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown bel ow. The size must be
smaller then the outer edge.
Figure 3-15: Cutout Dimensions
Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (
8Figure 3-16
n
).
Step 6: Insert the panel mounting clamps into the holes of the panel mounting bra ckets
(
8Figure 3-16
o
). There are a total of 4 panel mounting clamps for
AFL2-W10A-N28.