User Manual

AFL2-W10A-N28 Panel PC
Page 28
Step 6: Insert the four monitor mounting screws provided in the wall mo unt kit into the
four screw holes on the real p anel of the flat bezel p an el PC and tighten until the
screw shan k is secured against the rear panel (
8Figure 3-13).
WARNING:
Please use the M4 screws provided in the wall mount kit for the rear panel.
If the screw is missing, the thread depth of the replacement screw should
be not more than 4 mm.
Step 7: Align the mounting screws on the monitor rear panel with the mounting holes on
the bracket.
Step 8: Carefully insert the screws through the holes and gently pull the monitor
downwards until the monitor rests securely in the slotted holes (
8Figure 3-13).
Ensure that all four of the mounting screws fit snugly into their re spective slotted
holes.
NOTE:
In the diagram below the bracket is already installed on the wall.