User guide

AFL2-17A/AB-H61
Page 64
5.13.2 Panel Mounting
To mount the AFL2-17A/AB-H61 flat bezel panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the panel to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller than the outer edge.
Figure 5-19: Cutout Dimensions
Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (Figure 5-20

).
Step 6: Insert the panel mounting clamps into the holes of the panel mounting brackets
(Figure 5-20

). There are a total of 4 panel mounting clamps for
AFL2-17A/AB-H61.
Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel.