Owner's manual

AFL2-15A-H61
Page 34
Step 4: Secure the AFL2-15A-H61 to the interface pad by inserting four retention screws
through the mounting arm interface pad and into the AFL2-15A-H61.Step 0:
Figure 3-18: Arm Mounting (ARM-11-RS)
3.12.3 Stand Mounting
To mount the AFL2-15A-H61 using the stand mounting kit, please follow the steps below.
Step 1: Locate the screw holes on the rear of the AFL2-15A-H61. This is where the
bracket will be attached.
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the AFL2-15A-H61 insert the retention screws into the
screw holes and tighten them.Step 0: