Owner manual

AFL2-12A-HM65 Series Panel PC
Page 34
Figure 4-9: Cutout Dimensions
Step 3: Slide the flat panel PC through the hole until the frame is flush against the panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes (
Figure 4-10
n
).
Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges
of the panel mounting brackets (
Figure 4-10
o
). There are a total of 4 panel
mounting clamps for AFL2-12A-HM65.
Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
(
Figure 4-10
p
). Step 7: