Manual

AFL2-12A-HM65 Series Panel PC
Page 68
Step 8: Install the new DDR3 memory module by pushing it into the socket at an angle
(Figure 5-3).
Step 9: Gently pull the spri
ng retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 5-3).
Step 10: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
Figure 5-3: DDR SO-DIMM Module Installation
Step 11: Replace the internal aluminum cover and secure it to the chassis using six (6)
retention screws.
Step 12: Replace the back cover and secure it using nine (9) previously removed
retention screws. Step 0:
5.5.2 WLAN Card Replacement
The AFL2-12A-HM65 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section 5.2.
Step 2: T
urn off the power. See Section 5.3.
Step 3: Remove the
back cover. See Section 5.4.1.
Step 4: Remove the i
nternal aluminum back cover. See Section 5.4.2.