Manual

AFL2-12A-HM65 Series Panel PC
Page 51
4.8.2 Stand Mounting
To mount the AFL2-12A-HM65 using the stand mounting kit, please follow the steps
below.
Step 1: Locate the screw holes on the rear of the AFL2-12A-HM65. This is where the
bracket will be attached. (Figure 4-10)
Figure 4-10: Mounting screw location
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the AFL2-12A-HM65, insert the retention screws into
the screw holes and tighten them. Step 0:
4.8.3 Arm Mounting
The AFL2-12A-HM65 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100mm interface pad. To mount the AFL2-12A-HM65
on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.