Instruction Manual

AFL2-08A-N26
Page 63
Figure 6-4: DDR SO-DIMM Module Installation
Step 11: Replace the internal aluminum cover and secure it to the chassis using five (5)
retention screws.
Step 12: Replace the back cover and secure it using ten (10) previously removed
retention screws. Step 0:
6.5.2 WLAN Card Replacement
The AFL2-08A-N26 has one WLAN card slot. To replace the WLAN card, follow the
instructions below.
Step 1: Follow all anti-static procedures. See Section 6.2.
Step 2: Turn off the power. See Section 6.3.
Step 3: Remove the back cover. See Section 6.4.1 above.
Step 4: Remove the internal back cover. See Section 6.4.2 above.
Step 5: Locate the WLAN card.
Step 6: Disconnect the main and auxiliary antennas on the WLAN module and push the
two spring clips in to release the WLAN card (Figure 6-5).