Instruction Manual

AFL2-08A-N26
Page 35
4.11.3 Stand Mounting
To mount the AFL2-08A-N26 using the stand mounting kit, please follow the steps below.
Step 1: Locate the screw holes on the rear of the AFL2-08A-N26. This is where the
bracket will be attached. (Figure 4-14)
Figure 4-14: Mounting screw location
Step 2: Align the bracket with the screw holes.
Step 3: To secure the bracket to the AFL2-08A-N26, insert the retention screws into the
screw holes and tighten them. Step 0:
4.12 External Peripheral Device Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
 Audio devices
 Display devices
 RJ-45 Ethernet cable connector
 Serial port devices
 USB devices