Owner's manual
Table Of Contents
- 42AFL-xxA-N270 Series Flat Panel PC
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Installation
- 4.1 Anti-static Precautions
- 4.2 Installation Precautions
- 4.3 Preinstalled Components
- 4.4 Installation and Configuration Steps
- 4.5 Removing the Back Cover
- 4.6 CF Card Installation
- 4.7 HDD Installation (AF-12A-N270 Only)
- 4.8 AT/ATX Mode Selection
- 4.9 Jumper Settings
- 4.10 Mounting the System
- 4.11 Bottom Panel Connectors
- 5 System Maintenance
- 6 AMI BIOS Setup
- 7 Software Drivers
- A System Specifications
- B Safety Precautions
- C BIOS Configuration Options
- D Watchdog Timer
- E Hazardous Materials Disclosure
- F Index
AFL-xxA-N270 Series Panel PC
Page 60
Figure 5-1: Back Cover Retention Screws
Step 4: Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws (
Figure 4-2). More strength is
required to separate the cover from the chassis. Step 0:
Figure 5-2: AFL-xxA-N270 Plastic Back Cover Removal
5.4.2 AFL-xxA-N270 Series Internal Aluminum Cover Removal
To remove the internal aluminum cover, follow the steps below.
Step 1: Remove the retention screws securing the internal aluminum cover. The screw
numbers are varied in different models.
Figure 5-3 shows the aluminum cover
retention screws of the AFL-10A-N270.