Owner's manual
Table Of Contents
- 42AFL-xxA-N270 Series Flat Panel PC
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Installation
- 4.1 Anti-static Precautions
- 4.2 Installation Precautions
- 4.3 Preinstalled Components
- 4.4 Installation and Configuration Steps
- 4.5 Removing the Back Cover
- 4.6 CF Card Installation
- 4.7 HDD Installation (AF-12A-N270 Only)
- 4.8 AT/ATX Mode Selection
- 4.9 Jumper Settings
- 4.10 Mounting the System
- 4.11 Bottom Panel Connectors
- 5 System Maintenance
- 6 AMI BIOS Setup
- 7 Software Drivers
- A System Specifications
- B Safety Precautions
- C BIOS Configuration Options
- D Watchdog Timer
- E Hazardous Materials Disclosure
- F Index
AFL-xxA-N270 Series Panel PC
Page 32
4.6 CF Card Installation
The AFL-xxA-N270 series has one CF Type II slot inside the rear panel. To install the CF
card, follow the instructions below.
Step 1: Locate the CF slot. Insert a CF card into the slot (
Figure 4-3).
Figure 4-3: CF Card Location
Step 2: Replace the plastic back cover. For AFL-08AH-N270, more strength is required
when pushing the bottom part of the cover down to the chassis (
Figure 4-4).
Figure 4-4: AFL-08AH-N270 Plastic Back Cover Replacement
Step 3: Once replaced reinsert the nine previously removed retention screws. Step 0: