Owner's manual
Table Of Contents
- 42AFL-xxA-N270 Series Flat Panel PC
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Installation
- 4.1 Anti-static Precautions
- 4.2 Installation Precautions
- 4.3 Preinstalled Components
- 4.4 Installation and Configuration Steps
- 4.5 Removing the Back Cover
- 4.6 CF Card Installation
- 4.7 HDD Installation (AF-12A-N270 Only)
- 4.8 AT/ATX Mode Selection
- 4.9 Jumper Settings
- 4.10 Mounting the System
- 4.11 Bottom Panel Connectors
- 5 System Maintenance
- 6 AMI BIOS Setup
- 7 Software Drivers
- A System Specifications
- B Safety Precautions
- C BIOS Configuration Options
- D Watchdog Timer
- E Hazardous Materials Disclosure
- F Index
AFL-xxA-N270 Series Panel PC
Page 31
4.5 Removing the Back Cover
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-xxA-N270 internally the back cover must be removed. To remove the
back cover, please follow the steps below.
Step 1: Remove the retention screws (
Figure 4-1) and lift the cover off the flat panel PC.
Figure 4-1: Back Cover Retention Screws
Step 2: Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws (
Figure 4-2). More strength is
required to separate the cover from the chassis. Step 0:
Figure 4-2: AFL-xxA-N270 Plastic Back Cover Removal