Owner's manual
Table Of Contents
- 42AFL-xxA-N270 Series Flat Panel PC
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Installation
- 4.1 Anti-static Precautions
- 4.2 Installation Precautions
- 4.3 Preinstalled Components
- 4.4 Installation and Configuration Steps
- 4.5 Removing the Back Cover
- 4.6 CF Card Installation
- 4.7 HDD Installation (AF-12A-N270 Only)
- 4.8 AT/ATX Mode Selection
- 4.9 Jumper Settings
- 4.10 Mounting the System
- 4.11 Bottom Panel Connectors
- 5 System Maintenance
- 6 AMI BIOS Setup
- 7 Software Drivers
- A System Specifications
- B Safety Precautions
- C BIOS Configuration Options
- D Watchdog Timer
- E Hazardous Materials Disclosure
- F Index
AFL-xxA-N270 Series Panel PC
Page 143
C.1 BIOS Configuration Options
Below is a list of BIOS configuration options described in Chapter 6.
System Overview .................................................................................................................67
System Time [xx:xx:xx].......................................................................................................68
System Date [xx/xx/xx]........................................................................................................68
ATA/IDE Configurations [Compatible]...............................................................................70
Legacy IDE Channels [PATA Pri, SATA Sec]....................................................................71
IDE Master and IDE Slave....................................................................................................71
Auto-Detected Drive Parameters........................................................................................72
Type [Auto]...........................................................................................................................73
ZIP..........................................................................................................................................73
LS-120 ...................................................................................................................................73
LBA/Large Mode [Auto].......................................................................................................74
Block (Multi Sector Transfer) [Auto]..................................................................................74
PIO Mode [Auto]...................................................................................................................74
DMA Mode [Auto].................................................................................................................75
S.M.A.R.T [Auto]...................................................................................................................76
32Bit Data Transfer [Enabled].............................................................................................76
Serial Port1 Address [3F8/IRQ4] ........................................................................................77
Serial Port1 Mode [Normal].................................................................................................77
Serial Port3 Address [3E8]..................................................................................................78
Serial Port3 IRQ [11] ............................................................................................................78
Serial Port4 Address [2E8]..................................................................................................78
Serial Port4 IRQ [10] ............................................................................................................78
CPU FAN Mode Setting [Full On Mode].............................................................................79
CPU Temp. Limit of OFF [000] ............................................................................................80
CPU Temp. Limit of Start [020]...........................................................................................80
CPU Fan Start PWM [070]....................................................................................................81
Slope PWM [0.5 PWM].......................................................................................................81
Suspend Mode [S1(POS)]....................................................................................................84
Restore on AC Power Loss [Last State]............................................................................84
Power Button Mode [On/Off]...............................................................................................85
Resume on Keyboard/Mouse [Disabled]...........................................................................85