Owner's manual
Table Of Contents
- 42AFL-xxA-N270 Series Flat Panel PC
- 1 Introduction
- 2 Detailed Specifications
- 3 Unpacking
- 4 Installation
- 4.1 Anti-static Precautions
- 4.2 Installation Precautions
- 4.3 Preinstalled Components
- 4.4 Installation and Configuration Steps
- 4.5 Removing the Back Cover
- 4.6 CF Card Installation
- 4.7 HDD Installation (AF-12A-N270 Only)
- 4.8 AT/ATX Mode Selection
- 4.9 Jumper Settings
- 4.10 Mounting the System
- 4.11 Bottom Panel Connectors
- 5 System Maintenance
- 6 AMI BIOS Setup
- 7 Software Drivers
- A System Specifications
- B Safety Precautions
- C BIOS Configuration Options
- D Watchdog Timer
- E Hazardous Materials Disclosure
- F Index

AFL-xxA-N270 Series Panel PC
Page XII
List of Figures
Figure 1-1: AFOLUX AFL-xxA-N270 Flat Panel PC......................................................................2
Figure 1-2: AFL-xxA-N270 Front View ..........................................................................................4
Figure 1-3: AFL-xxA-N270 Rear View ...........................................................................................4
Figure 1-4: AFL-xxA-N270 I/O Interface Connector Panel..........................................................5
Figure 1-5: AFL-xxA-N270 Top View.............................................................................................6
Figure 1-6: AFL-10A-N270 Side View............................................................................................6
Figure 2-1: AFL-07A-N270 Dimensions (mm) ............................................................................10
Figure 2-2: AFL-08AH-N270 Dimensions (mm)..........................................................................11
Figure 2-3: AFL-10A-N270 Top and Bottom Panel Dimensions (mm).....................................12
Figure 2-4: AFL-12A-N270 Top and Bottom Panel Dimensions (mm).....................................13
Figure 2-5: Preinstalled DDR2 SO-DIMM....................................................................................15
Figure 2-6: COM Ports..................................................................................................................16
Figure 2-7: RJ-45 Ethernet Connectors......................................................................................16
Figure 2-8: External USB Ports ...................................................................................................17
Figure 2-9: LCD Screen................................................................................................................18
Figure 2-10: Audio Jack...............................................................................................................18
Figure 2-11: Stereo Speakers......................................................................................................19
Figure 2-12: Power Connector ....................................................................................................20
Figure 2-13: PIFA Antenna and Wireless Module......................................................................22
Figure 4-1: Back Cover Retention Screws.................................................................................31
Figure 4-2: AFL-xxA-N270 Plastic Back Cover Removal..........................................................31
Figure 4-3: CF Card Location ......................................................................................................32
Figure 4-4: AFL-08AH-N270 Plastic Back Cover Replacement................................................32
Figure 4-5: AF-12A-N270 HDD Retention Screws......................................................................33
Figure 4-6: AT/ATX Switch Location...........................................................................................34
Figure 4-7: Clear CMOS Jumper .................................................................................................38
Figure 4-8: COM1 and COM3 Pin 9 Setting Jumper Locations................................................39
Figure 4-9: COM3 RX Function Select Jumper Location..........................................................40
Figure 4-10: COM3 TX Function Select Jumper Pinout Locations..........................................41
Figure 4-11: COM3 RS-232/422/485 Serial Port Select Jumper Location................................43
Figure 4-12: Wall-mounting Bracket...........................................................................................44