User Manual

AFL-W19A/W19B/17D/W15A-GM45 Panel PC
Page 18
Figure 2–6: CompactFlash® Install
Step 4: Slide the cover back on, then fasten the screw.Step 0:
2.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to close an electrical circuit. It
consists of two metal pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect them. To
CLOSE/SHORT a jumper means connecting the pins of the jumper
with the plastic clip and to OPEN a jumper means removing the plastic
clip from a jumper.
The motherboard jumpers are listed below.
 COM1 pin 9 setup
 COM3 pin 9 setup
 COM3 RS-232/422/485 selection
2.5.1 COM1 Pin-9 Setup
Jumper Label: JP11
Jumper Type:
10-pin header