Instruction Manual
AFL-W19A/17D/W15A-N270 Panel PC
Page 20
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
Table 2-5.
Clear CMOS Description
Short 1 - 2 Keep CMOS Setup
Short 2 - 3 Clear CMOS Setup
Table 2-5: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 2-9 below.
Figure 2-9: Clear CMOS Jumper
2.5.5 COM Port Pin 9 Select
Jumper Label: JP6 and JP7
Jumper Settings:
See
Table 2-6
Jumper Type:
6-pin header
Jumper Location:
See
Figure 2-10
Two jumpers (JP6 and JP7) configure pin 9 on COM1 and COM3 DB-9 connectors. Pin 9
on the COM1 and the COM3 DB-9 connectors can be set as the ring (RI) signal, +5 V or
+12 V. The COM1 and COM3 Pin 9 Setting jumper selection options are shown in
Table
2-6.