User guide

AFL-W10A-N270 User Manual
Page iv
Table of Contents
1 INTRODUCTION.......................................................................................................... 1
1.1 OVERVIEW.................................................................................................................. 2
1.1.1 Features ............................................................................................................. 3
1.2 EXTERNAL OVERVIEW................................................................................................ 3
1.2.1 Front Panel ........................................................................................................ 3
1.2.2 Rear Panel ......................................................................................................... 4
1.2.3 I/O Interface Panel ............................................................................................ 5
1.3 INTERNAL OVERVIEW................................................................................................. 6
1.4 SYSTEM SPECIFICATIONS............................................................................................ 7
1.5 DIMENSIONS............................................................................................................... 8
2 INSTALLATION ......................................................................................................... 10
2.1 UNPACK THE PANEL PC.............................................................................................11
2.1.1 Packing List ..................................................................................................... 12
2.2 REMOVING THE REAR PANEL ................................................................................... 15
2.3 CF CARD INSTALLATION .......................................................................................... 16
2.4 AT /ATX MODE SELECTION...................................................................................... 18
2.4.1 AT Power Mode................................................................................................ 18
2.4.2 ATX Power Mode ............................................................................................. 19
2.5 JUMPER SETTINGS .................................................................................................... 19
2.5.1 Access the Jumpers .......................................................................................... 20
2.5.2 Preconfigured Jumpers .................................................................................... 20
2.5.3 Clear CMOS Jumper........................................................................................ 21
2.5.4 COM Port Pin 9 Select .................................................................................... 22
2.5.4.1 COM3 RS-422 and RS-485 Pinouts ......................................................... 23
2.5.5 COM3 RX Function Select Jumper.................................................................. 23
2.5.6 COM3 TX Function Select Jumper.................................................................. 24
2.5.7 COM3 RS-232/422/485 Serial Port Select Jumper ......................................... 25
2.5.8 CompactFlash® Setup..................................................................................... 26
2.6 MOUNTING THE SYSTEM .......................................................................................... 27
2.6.1 Wall Mounting.................................................................................................. 28