Owner manual

AFL-W10A-N270 User Manual
Page 54
3.4 Memory Module Replacement
The panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory module is
fail, follow the instructions below to replace the memory module.
Step 7: Remove the aluminum back cover. See Section 3.3 above.
Step 8: Locate the DDR2 SO-DIMM on the motherboard (
Figure 3-4).
Figure 3-4:AFL-W10A-N270 SO-DIMM Socket Location
Step 9: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 10: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 11: Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 3-5).
Step 12: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 3-5).
Step 13: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.Step 0: