Owner manual

AFL-F08A-N270 Panel PC
Page x
List of Figures
Figure 1-1: AFL-F08A-N270 Flat Panel PC ...................................................................................2
Figure 1-2: AFL-F08A-N270 Front View........................................................................................3
Figure 1-3: AFL-F08A-N270 Rear View .........................................................................................5
Figure 1-4: AFL-F08A-N270 I/O Interface Connector Panel........................................................6
Figure 1-5: Main Dimensions.........................................................................................................8
Figure 1-6: Rear Dimensions.........................................................................................................9
Figure 3-1: Back Cover Retention Screws.................................................................................17
Figure 3-2: Pry The Rear Cover Off.............................................................................................17
Figure 3-3: CompactFlash® Card Cover Screw.........................................................................18
Figure 3-4: CompactFlash® Install .............................................................................................18
Figure 3-5: Internal Cover Removal............................................................................................19
Figure 3-6: Internal Components ................................................................................................19
Figure 3-7: AT/ATX Power Selection Switch..............................................................................22
Figure 3-8: Clear CMOS Jumper .................................................................................................23
Figure 3-9: COM1 and COM3 Pin 9 Setting Jumper Locations................................................24
Figure 3-10: COM3 RX Function Select Jumper Location........................................................25
Figure 3-11: COM3 TX Function Select Jumper Pinout Locations..........................................26
Figure 3-12: COM3 RS-232/422/485 Serial Port Select Jumper Location................................28
Figure 3-13: CompactFlash® Setup Jumper Location .............................................................29
Figure 3-14: Wall-mounting Bracket...........................................................................................30
Figure 3-15: Chassis Support Screws........................................................................................31
Figure 3-16: Secure the Panel PC ...............................................................................................32
Figure 3-17: Tighten the Panel Mounting Clamp Screws .........................................................33
Figure 3-18: Arm Mounting Retention Screw Holes..................................................................34
Figure 3-19: The Rack/Cabinet Bracket......................................................................................35
Figure 3-20: Secure the Rack/Cabinet Bracket..........................................................................35
Figure 3-21: Install into a Rack/Cabinet .....................................................................................36
Figure 3-22: LAN Connection......................................................................................................37
Figure 3-23: Serial Device Connector.........................................................................................38
Figure 3-24: USB Device Connection .........................................................................................40