Owner's manual

AFL-F08A-N270 Panel PC
Page 42
Figure 4-1: AFL-F08A-N270 SO-DIMM Socket Location
Step 2: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 3: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 4: Install the new DDR memory module by pushing it into the socket at an angle
(
543H543HFigure 4-2).
Step 5: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
544H544HFigure 4-2).
Step 6: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.Step 0: