User Manual

AFL-F08A Panel PC
Page viii
List of Figures
Figure 1-1: AFL-F08A Flat Panel PC .............................................................................................2
Figure 1-2: AFL-F08A Front View..................................................................................................3
Figure 1-3: AFL-F08A Rear View...................................................................................................4
Figure 1-4: AFL-F08A I/O Interface Connector Panel..................................................................5
Figure 1-5: Main Dimensions.........................................................................................................7
Figure 1-6: Rear Dimensions.........................................................................................................8
Figure 3-1: Back Cover Retention Screws.................................................................................16
Figure 3-2: Pry The Rear Cover Off.............................................................................................16
Figure 3-3: CompactFlash® Card Cover ....................................................................................17
Figure 3-4: CompactFlash® Install .............................................................................................17
Figure 3-5: Internal Cover Removal............................................................................................18
Figure 3-6: Internal Components ................................................................................................18
Figure 3-7: AT/ATX Power Selection Switch..............................................................................21
Figure 3-8: Clear CMOS Jumper .................................................................................................22
Figure 3-9: COM1 and COM3 Pin 9 Setting Jumper Locations................................................23
Figure 3-10: COM3 RX Function Select Jumper Location........................................................24
Figure 3-11: COM3 TX Function Select Jumper Pinout Locations..........................................25
Figure 3-12: COM3 RS-232/422/485 Serial Port Select Jumper Location................................27
Figure 3-13: Wall-mounting Bracket...........................................................................................28
Figure 3-14: Chassis Support Screws........................................................................................29
Figure 3-15: Secure the Panel PC ...............................................................................................30
Figure 3-16: Tighten the Panel Mounting Clamp Screws .........................................................31
Figure 3-17: Arm Mounting Retention Screw Holes..................................................................32
Figure 3-18: The Rack/Cabinet Bracket......................................................................................33
Figure 3-19: Secure the Rack/Cabinet Bracket..........................................................................33
Figure 3-20: Install into a Rack/Cabinet .....................................................................................34
Figure 3-21: LAN Connection......................................................................................................35
Figure 3-22: Serial Device Connector.........................................................................................36
Figure 3-23: USB Device Connection .........................................................................................38
Figure 4-1: AFL-F08A SO-DIMM Socket Location .....................................................................41