Manual

AFL-4 Series-N270 User Manual
Page 67
Figure 4-25: Tighten the In-wall Mounting Screws
4.10.3 Arm Mounting
The AFL-4 Series-N270 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 75mm or 100mm interface pad. To mount the AFL-4
Series-N270 on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFL-4 Series-N270 flat panel
PC. The AFL-4 Series-N270 also support VESA MIS-D 100.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.