Manual

AFL-4 Series-N270 User Manual
Page 64
Figure 4-19: Attach Foam Tape
Step 3: Attach the adhesive foam tape to the edge of rear panel of the AFL-4
Series-N270 (see Figure 4-19).
Make sure the adhesive tape does not cover
the screw holes as shown below. Step 0:
Figure 4-20: Foam Tape Installed
To mount the AFL-4 Series-N270 panel PC into a wall, please follow the steps below.
Step 1: Select the position on the wall to mount the flat panel PC.
Step 2: Cut out a section from the wall that corresponds to the dimensions in Figure
4-21 fo
r the AFL-408A/B or Figure 4-214 for the
AFL-W410A or Figure 4-23 for
the AFL-412A or Figure 4-216 for the
AFL-415A/AE. Take care that the wall
section that is cut out is no larger than the suggested cut out size for the
corresponding panel PC.