User guide

AFL-4 Series-N270 User Manual
Page 76
Figure 5-2: AFL-412A-N270 SO-DIMM Socket Location
Step 3: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 4: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 5: Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 5-3).
Step 6: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 5-3).
Step 7: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.Step 0: