User guide

AFL-4 Series-N270 User Manual
Page 75
Figure 5-1: Back Cover Retention Screws
Step 5: Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws. More strength is required to
separate the cover from the chassis. Step 0:
5.5 Replacing Components
5.5.1 Memory Module Replacement
The flat panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory
module is fail, follow the instructions below to replace the memory module.
Step 1: Remove the aluminum back cover. See Section
5.4.1 above.
Step 2: Locate the DDR2 SO-DIMM on the motherboard (
Figure 5-2).