Owner manual

AFL-HM55 Series Panel PC
Page 25
3.8 Removing the Internal Aluminum Cover
WARNING:
Over-tightening rear cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To remove the internal aluminum cover, follow the steps below.
Step 1: Remove sixteen (16) retention screws securing the internal aluminum cover.
Figure 3-6 shows the aluminum cover retention screws of the AFL-HM55
Series.
Figure 3-6: AFL-HM55 Series Aluminum Back Cover Retention Screws
Step 2: Lift the aluminum cover away to expose the mainboard jumpers.