Owner manual

AFL-HM55 Series Panel PC
Page 24
3.7 Removing the Rear Panel Cover
WARNING:
Over-tightening rear cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-HM55 internally, the rear panel cover must first be removed. To remove
the rear panel cover, please follow the steps below.
Step 1: Remove twenty-one (21) retention screws from the rear panel cover. See
Figure
3-5.
Figure 3-5: AFL-HM55 Series Back Cover Retention Screws
Step 2: Lift the cover off the AFL-HM55 Series panel PC.