Manual

AFOLUX AFL-15A-N270 Panel PC
Page 68
5.5 Replacing Components
5.5.1 Memory Module Replacement
The flat panel PC is preinstalled with a 1.0 GB DDR2 memory module. If the memory
module is fail, follow the instructions below to replace the memory module.
Step 1: Remove the back cover. See Section
5.4.1 above.
Step 2: Remove the internal aluminum back cover. See Section
5.4.2 above.
Step 3: Locate the DDR2 SO-DIMM on the motherboard (
Figure 5-3).
Figure 5-3: SO-DIMM Socket Location
Step 4: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 5: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 6: Install the new DDR memory module by pushing it into the socket at an angle
(
Figure 5-4).
Step 7: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (
Figure 5-4).