User Manual

AFL-08AH-N270-CR Panel PC
Page 25
Step 3: Remove the retention screws securing the internal aluminum cover (Figure 5-2).
Figure 4-2: Aluminum Back Cover Retention Screws
Step 4: Lift the aluminum cover off the AFL-08AH-N270-CR. Step 0:
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper.
4.6.1 Access the Jumpers
To access the jumpers, remove the back cover. To remove the back cover, please refer to
Section
4.5.