User Manual

AFL-08AH-N270-CR Panel PC
Page 24
4.5 Removing the Back Cover
WARNING:
Do not modify this equipment without authorization of the
manufacturer.
Only certified engineers should install and modify the hardware
settings. Incorrect settings can cause irreparable damage to the
system.
WARNING:
Over-tightening back cover screws will crack the plastic frame.
Maximum torque for cover screws is 5 kg-cm (0.36 lb-ft/0.49 Nm).
To access the AFL-08AH-N270-CR internally the back cover must be removed. To remove
the back cover, please follow the steps below.
Step 1: Remove the retention screws (
Figure 4-1) and lift the cover off the flat panel PC.
Figure 4-1: Back Cover Retention Screws
Step 2: Lift the back cover off the system.