Instruction Manual

AFOLUX LX Panel PC
Page 27
Step 3: Locate the CF slot. Insert a CF card into the slot (Figure 3-2).
Figure 3-2: CF Card Location
Step 4: Replace the plastic back cover. A bit of force is needed when pushing the bottom
part of the cover down to the chassis.
Step 5: Once replaced reinsert the nine previously removed retention screws. Step 0:
3.6 AT/ATX Mode Selection
AT and ATX power modes can both be used on the AFOLUX LX. The selection is made
through an AT/ATX switch on the rear panel (
Figure 3-3). To select AT mode or ATX
mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the aluminum chassis (
Figure 3-3).
Figure 3-3: AT/ATX Switch Location
Step 2: Adjust the AT/ATX switch. Step 0: