Installation Guide

Page
7
of
16
Ver No.: 0.11D
Ver Date: 05-05-2020
Information included in this document is the property of IEE S.A. Copy, use or disclosure of its contents, even in part, is not permitted without the prior written
agreement of IEE. This document is strictly IEE confidential.
User Manual
1.5 T Harness
The T-Shaped wiring harness is used to interface individual sensors to the LIN network. One
T- harness is used to connect one sensor to the LIN network. A system with ‘n’ number of
sensors will need ‘n’ number of harnesses. The horizontal side of the ‘T’ harness will have a
male connector on one side and female on the other. The vertical line of the ‘T’ connects to
the sensor head.
Female Connector Male Connector Sensor Connector
Figure 5: T Harness
1.6 GSM Modem
The GSM module performs the required cell phone communication. The GSM module is
connected to the Universal Serial Bus (USB) port of the CCU and is located inside the CCU
housing.
Figure 6: GSM Module
This will be replaced with an antenna unit
1.7 LiDAS System Battery