Installation Guide

Page
5
of
16
Ver No.: 0.11D
Ver Date: 05-05-2020
Information included in this document is the property of IEE S.A. Copy, use or disclosure of its contents, even in part, is not permitted without the prior written
agreement of IEE. This document is strictly IEE confidential.
User Manual
1.2 Sensor Housing
The UCD Sensors are secured within the sensor housing before installing on the vehicle. It
has a ‘U’ shaped notch on both sides (circled in red in Figure 2 below). Depending on
convenience, one of these notches will be cut out to route the wiring to the sensor. The LIN
network harness must be connected to the UCD sensor before installation of the sensor and
its housing to the vehicle. The housing has a custom locking mechanism that holds the sensor.
Use two screws, one on either side of sensor housing to mount the housing to the headliner.
Sensor locking position Screw holes
Figure 2: Sensor Housing
1.3 Central Control Unit
The Central Control Unit (CCU) is a box type structure with size 20 cm X 12 cm X 5 cm. It is
connected to UCD sensors, LiDAS System Battery, Vehicle Ignition, Driver Interface Module
and the Global System for Mobile communications (GSM) Module. The CCU is placed in a
protective housing and can be located in an appropriate, non-intrusive location. A typical
location is behind the driver seat.