Installation Guide

Page
4
of
16
Ver No.: 0.11D
Ver Date: 05-05-2020
Information included in this document is the property of IEE S.A. Copy, use or disclosure of its contents, even in part, is not permitted without the prior written
agreement of IEE. This document is strictly IEE confidential.
User Manual
1. List of Components
1.1 UCD SENSOR
Unattended Child Detection (UCD) sensors are mounted on the bus or van head liner above
alternating seat benches after inserting the UCD into the Senor Housing holder (see Section
1.2). The position and total number of UCD sensors depends on the height and vehicle size.
The top side of each sensor is labelled with Software version, Frequency used and Node
number of the UCD. The odd number nodes are installed on the left side (behind the driver)
and even number nodes on the right side of the vehicle. Transceiver antennas are located on
the bottom side of the UCD (see Figure 1). While installing, the bottom side must face the
seats.
Top Side Bottom Side
Node Number Connector Head Position of Transceiver Antenna
Figure 1:UCD Sensor Top and Bottom View and Pin Information