Data Sheet

CLEANING

•

Regularly clean the inside and outside of the refrigerator using only warm water and a neutral detergent.

•

Subsequent to washing, rinse with clean water and dry thoroughly using a soft cloth.

•

Do not use the following: special glass and mirror cleaning products, liquid, powder, or spray detergents,

alcohol, ammonia or abrasive products.

•

If you are not using the refrigerator, we suggest cleaning it well inside and leaving the door half open to

ventilate the interior.

SUGGESTIONS

Should the device fail to work or work badly, before referring to our after-sales service, make sure that:

a) the feeding voltage is not missing;

b) the voltage is the same as the one shown on the plate;

c) the connections and the polarities are right;

d) the airing grids are not covered over;

e) the refrigerator unit is not near any heat source;

f) the fuse of the feeding line is not blown.

The power supply cable must be replaced only by qualified technical personnel and in any case by an

after sales service authorised by the Manufacturer.

ICECO is not liable in any way if you do not comply strictly with all the previsions in this manual.

FAULTS

When there is error for the fridge, there will be code on the display. The possible error for each code would

be as follows

ERROR

CODE

ERROR TYPE

Fan error/Short circuit/ Frequently start and stop

The motor speed of the compressor is too low (the refrigeration system is overloaded, the motor

cannot maintain the minimum speed of 1850r/min)

Temperature too high or too low to protect the compressor control module (when the

environment temperature is too high or too low, or system load is too large, causing module/ECU

internal temperature 100 °C > or < - 10 °C)

NTC fault (NTC open circuit or short circuit)