User manual

IDUINO for Maker’s life

www.openplatform.cc

IR Receiver Module(ST1089)

1．Introduction

This module usually used together with the IR transmit Module(Item:ST1087),

This module can read infrared light value and print in the Serial Monitor session.

Specification

 Operation voltage: 5V

 3Pin

 Size:25*12mm

 Weight: 2g

2 Pinout

Description

Digital signal input pin, used to read the

value of infrared light.

+(middle pin)

Power

Ground

3.Example

In this example, you need an Infrared transmit device, like Item ST1087, or mini

remote controller, directly point the remoter to this module, which can read the

hexadecimal value of the infrared light and print on the window.

The connection as below:

PAGE 1
IDUINO for Maker’s life IR Receiver Module(ST1089) 1．Introduction This module usually used together with the IR transmit Module(Item:ST1087), This module can read infrared light value and print in the Serial Monitor session. Specification  Operation voltage: 5V  3Pin  Size:25*12mm  Weight: 2g 2 Pinout Pin S +(middle pin) - Description Digital signal input pin, used to read the value of infrared light. Power Ground 3.
PAGE 2
IDUINO for Maker’s life Example code : ******Code begin****** # Include int RECV_PIN = 11; // define input pin on Arduino IRrecv irrecv (RECV_PIN); decode_results results; void setup () { Serial.begin (9600); irrecv.enableIRIn (); // Start the receiver } void loop () { if (irrecv.decode (& results)) { Serial.println (results.value, HEX); irrecv.resume (); // Receive the next value } }******Code End****** www.openplatform.