Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Touch Sensor(SE061)

1 Introduction

This module is a metal touch sensor, it looks like module7(flame sensor module),

has 4 pin, including one analog pin and digital pin, but usually we just use the digital

pin. Which can be used to detect whether a human body is touching the metal detector.

Specification

 Operation voltage: 5V

 Both digital and analog output pin

 Adjustable sensitive

 Size: 30*15mm

 Weight: 3g

2 Pinout

Description

Analog output pin, real-time output

voltage signal(usually useless)

Digital output pin, output Low or High

signal when the human body touch it

Power(5V for analog, 3.3V for digital)

Ground

3Example

Here is a example show you how to use this module, connection as below. When you

touch the metal detector via your finger, the LED13 turns on.

PAGE 1
IDUINO for Maker’s life Touch Sensor(SE061) 1 Introduction This module is a metal touch sensor, it looks like module7(flame sensor module), has 4 pin, including one analog pin and digital pin, but usually we just use the digital pin. Which can be used to detect whether a human body is touching the metal detector.
PAGE 2
IDUINO for Maker’s life ********Code begin******** int Led = 13;// define LED Interface int buttonpin = 3; int val;// define numeric variables val void setup () { pinMode (Led, OUTPUT) ;//define LED as output interface pinMode (buttonpin, INPUT) ;// define metal touch sensor output interface } void loop () { val = digitalRead (buttonpin) ;//digital interface will be assigned a value of 3 to read val if (val == HIGH) //When the metal touch sensor detects a signal, LED flashes { digitalWrite (Led, HIGH); } e