Datasheet

IDUINO for Maker’s life

www.openplatform.cc

Flame Sensor Module(SE060)

1.Introduction

This is a flame sensor module that can be used to detected whether a flame source

exist or not. It’s sensitive to IR wavelength at 760nm~1100nm. Usually, the detection

angle is about 60 degrees.

Specification

 Operation voltage: 5V for analog, 3.3V for digital

 Both digital and analog output pin

 Adjustable sensitive

 Detect IR wavelength: 760nm~1100nm

 Size: 30*15mm

 Weight: 3g

2.Pinout

Description

Analog output pin, real-time output

voltage signal on thermal resistance

Digital output pin, output Low or High

signal when the temperature reaches a

certain threshold

Power(5V for analog, 3.3V for digital)

Ground

3.Example

PAGE 1
IDUINO for Maker’s life Flame Sensor Module(SE060) 1.Introduction This is a flame sensor module that can be used to detected whether a flame source exist or not. It’s sensitive to IR wavelength at 760nm~1100nm. Usually, the detection angle is about 60 degrees. Specification       Operation voltage: 5V for analog, 3.3V for digital Both digital and analog output pin Adjustable sensitive Detect IR wavelength: 760nm~1100nm Size: 30*15mm Weight: 3g 2.
PAGE 2
IDUINO for Maker’s life Here is a example for how to use both the analog pin(A0) and digital pin(D0), connect the circuit as below, upload this sketch, open the Serial Monitor, you will see the realtime value of the thermal resistance, and once the flame closing to it, the value will change. If the value reaches a certain threshold, the D0 pin will output High signal meanwhile the LED13 turns on. And threshold can be adjusted by potentiometer.
PAGE 3
IDUINO for Maker’s life Serial.println(sensor); // display tempature val = digitalRead (buttonpin) ;// digital interface will be assigned a value of 3 to read val if (val == HIGH) // When the flame sensor detects a signal, LED flashes { digitalWrite (Led, HIGH); } else { digitalWrite (Led, LOW); } delay(1000); } ********Code End******** www.openplatform.