Datasheet

IDUINO for Maker’s life
www.openplatform.cc
infrared light
Vcc
Power
Gnd
Ground
3.example
In this example, we use the basic sketch in the Arduino IDE, blinking this Infrared
LED. You can’t see the light through your light by your eye, but you can catch the
infrared light by an infrared receive device, like module 35, or just a camera.
The connection as below:
Example code :
******Code begin******
void setup() {
// initialize digital pin 13 as an output.
pinMode(13, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(13, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1000); // wait for a second
digitalWrite(13, LOW); // turn the LED off by making the voltage LOW
delay(1000); // wait for a second
}
******Code End******