User's Manual

11
GB
SET CURRENT ALTITUDE
When you first use the watch, it is important to set the current
altitude and local sea-level pressure so your ascending and
descending altitude can be accurately measured. You can
find the current altitude by comparing your position to a
topographical map, and then entering the value in the watch.
It is necessary to reset the altitude after being in a
pressurized chamber (i.e., airplane).
For instructions on setting the sea-level pressure, refer to the
next section.
Tip: You can also set the current altitude and alarm limits with
the help of the PC software (see PC section).
• Total accumulated maximum / minimum altitudes attained
during your trip
•Maximum / minimum altitude alert (sounds an alarm when
exceeded)
•Maximum ascending, maximum descending speeds
•Current vertical speed
•Rate of altitude change
The altitude is shown it two ways, as a numeric value indicating
your current altitude, and as a bar chart indicating changes in
altitude. Both values will change as you move about.
ACCESSING THE ALTIMETER OPTIONS
Press MODE to access the ALTI Mode, then press SELECT/+
to loop through the options.
NOTE
Diagram Instructions
1. Press and hold FUN/SET for 2 seconds while in
ALTI mode.
2. Use SELECT/+ or ST/SP/- to change the value.
3. Press FUN/SET to exit the setting mode.