User's Manual

ManualsBrandsIDT Technology ManualsElectronicsRemote Thermo-Hygro Sensor (Transmitter)

Wireless Weather Station

Model : BAR608HA

User Manual

BAR608HA_EN_R0C.p65 6/29/04, 4:51 PM1

Summary of content (18 pages)

PAGE 1
EN Wireless Weather Station Model : BAR608HA User Manual BAR608HA_EN_R0C.
PAGE 2
EN Barometer ............................................................... 10 CONTENTS Barometric Trend ................................................. 10 Contents ................................................................... 1 Set Unit and Altitude ............................................ 10 Introduction .............................................................. 2 Weather Forecast ................................................... 10 Product Overview .............................
PAGE 3
EN INTRODUCTION Thank you for selecting the Oregon ScientificTM Wireless Weather Station (BAR608HA). This device bundles precise time keeping, weather forecast, barometric trend with altitude adjustment, and indoor and outdoor temperature and humidity monitoring features into a single tool you can use from the convenience of your home. In this box, you will find: • Main unit • Remote sensor (THGR268) Keep this manual handy as you use your new product.
PAGE 4
EN PRODUCT OVERVIEW FRONT VIEW 1. SNOOZE / LIGHT button 2. Weather forecast & barometric trend area 3. Outdoor temperature & humidity area 4. Indoor temperature & humidity area 5. Clock / alarm area 6 Moon phase 7. and : increase or decrease setting / activate or deactivate Atomic Clock. 8. RESET hole 9. ((.)): view alarm status; set alarm 10. MEMORY button: view current, maximum and minimum temperature / humidity readings 11. CHANNEL button: switch remote sensor 12.
PAGE 5
EN BACK VIEW 1. 1 Wall mount 2. Battery compartment 3. Table stand REMOTE SENSOR (THGR122N) GETTING STARTED 2 3 4 BAR608HA_EN_R0C.
PAGE 6
EN REMOTE SENSOR (THGR268) 1 1 2 2 3 4 1. Wall mount hole 1. LCD display 2. RESET 2. LED Status indicator 3. Channel number (1 - 3) 4. Battery compartment (Battery compartment cover not shown) 5 BAR608HA_EN_R0C.
PAGE 7
1. BATTERIES Batteries are not supplied with this product. You will need to purchase 3 x UM-3 (AA) 1.5V alkaline batteries for the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries for the remote sensor. Press and hold MODE for 2 seconds to enter setting mode. or to change settings. 2. Press 3. Press MODE to confirm. TABLE STAND OR WALL MOUNT Insert batteries before first use, matching the polarity as shown in the battery compartment.
PAGE 8
EN For best results: SETUP SENSOR 1. Open the remote sensor battery compartment with a small Phillips screwdriver. • Insert the batteries and select the channel before you mount the sensor. 2. Insert 2 alkaline batteries (UM-3 or "AA" size 1.5V), matching the polarity as shown in the battery compartment. • Place the sensor out of direct sunlight and moisture. SWITCH OPTION Channel Channel 1 - 3. If you are using more than one sensor, select a different channel for each sensor. 3.
PAGE 9
CLOCK Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature and Humidity Areas show the status. ICON --- shows in outdoor temp / humidity area EN DATA TRANSMISSION This product shows the current time, and day of week in English, French, German, Italian, or Spanish. The US Atomic Clock in Boulder, Colorado automatically updates this information unless you disable the feature.
PAGE 10
EN TURN ATOMIC CLOCK ON/OFF ALARMS Perform this step if you cannot receive Atomic Clock signals. Press and hold for 2 seconds. Then, manually set the clock following the "Set Clock" instructions (below). This product is equipped with a 2-minute crescendo alarm. VIEW ALARM SETTINGS The signal icon indicates that the Atomic Clock feature is ON. No icon means that it is OFF Press ((.)). The alarm time and ((.)) status will show in the clock area.
PAGE 11
EN If no button is pressed, the alarm will automatically silence after 2 minutes. It will then sound again after 8 minutes. SET UNIT AND ALTITUDE BAROMETER 1. Press PRESSURE to select the unit of measurement: mb / hPa or inHg. 2. Press and hold PRESSURE for 2 seconds. 3. Select the altitude (-100 m to 2,500 m or -328 ft to 8,203 ft in increments of approximately 33 ft or 10 or to change the setting. Press m). Press PRESSURE to confirm.
PAGE 12
EN NOTE If you use a sensor that collects only temperature data, humidity will not be shown. TEMPERATURE AND HUMIDITY This product can display current, minimum, and maximum temperatures and humidity percentage information collected by the remote sensors and main (indoor) unit. MINIMUM / MAXIMUM RECORDS Press MEM to toggle between current, maximum (MAX) and minimum (MIN) records. To clear the records, press and hold MEM for 2 seconds. A beep will sound to confirm that the memory has been cleared.
PAGE 13
SAFETY AND CARE Clean the product with a slightly damp cloth and alcoholfree, mild detergent. Avoid dropping the product or placing it in a high-traffic location. TROUBLESHOOTING Check here before contacting our customer service department. WARNINGS This product is designed to give you years of service if handled properly. Observe the following guidelines: PROBLEM SYMPTOM Calendar Strange date / Change language ( P.9) month • Never immerse the product in water.
PAGE 14
EN PROBLEM SYMPTOM Remote sensor REMEDY SPECIFICATIONS Cannot change channel Check sensors. Only one sensor is working ( P.7) MAIN UNIT DIMENSIONS HxWxD 158 x 63 x 142 mm (6.2 x 2.5 x 5.5 inches) Data does not match main unit Initiate a manual sensor search ( P.8) Weight 366 g (12.96 ounces) with battery REMOTE SENSOR DIMENSIONS HxWxD 105 x 70 x 21 mm (4 x 2.7 x 0.8 inches) Weight 80.5 g (2.
PAGE 15
EN RELATIVE HUMIDITY CLOCK Range 25% to 95% Atomic Clock Resolution 1% Clock display HH:MM:SS Memory Minimum / maximum Hour format 12hr AM/PM Time zone PA (Pacific), MO (Mountain), CE (Central) or EA (Eastern) Calendar MM/DD; weekday in 5 languages (E, D, F, I, S) Alarm Single alarm with 2- minute crescendo and 8-minute snooze Auto or manual (disabled) BAROMETER Unit mb/hPa or inHg Range 700 to 1050 mb (20.67 to 30.01 inHg) Resolution 1 mb (0.
PAGE 16
EN However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ABOUT OREGON SCIENTIFIC Visit our website (www.oregonscientific.
PAGE 17
We 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation. Name: Oregon Scientific, Inc. Address: 19861 SW 95th Place, Tualatin, Oregon 97062 USA IC: 3277A - BAR608HA Telephone No.: 1-800-853-8883 WIRELESS WEATHER STATION Fax No.: 1-503-684-8883 IC: 3277A - THGR238N declare that the product REMOTE THERMO-HYGRO SENSOR Product No.