User's Manual

SCREEN DISPLAY
START YOUR WATCH (FIRST TIME)
After removing the watch from the package box, press
and hold top (1) button to activate it until the screen has
time display.
Press top (1) button to switch the displays between default
time (Time 1) and Time 2 (page X). Press middle (2)
button to continue set time profile (page X).
SET UP YOUR WATCH
IMPORTANT
 To ensure accurate calculations with your exercise, you are strongly recommended to
set the watch and user profiles before exercising.
 Remember to set the profiles after every battery replacement or reset.
EXIT TO DEFAULT TIME SCREEN
You could press and hold middle (2) button to exit from any display and directly
go back to the default time screen displays at any time.
SET TIME PROFILE
After starting the watch for the first time, you can enter TIME setup mode by pressing
middle (2) button.
1. Press bottom (3) button to start setting in order.
2. Toggle middle (2) button to select the option to set, they are Time 1, Date,
Time 2, Alarm, Beep and measurement Unit.
After select an option, press the following buttons to edit settings:
1. Press top (1) button to start a particular setting display.
2. Press top (1) button to increase value or select option; press bottom (3) button to
decrease value or select option.
3. Press middle (2) button to save setting and automatically move to another setting
display (if applicable).
1
2
3
4
1. :Indicates battery status is low or nearly empty
2. :Indicates beep tone is off
3. :Indicates exercise timer is activated; flashes
when counting
4. :Indicates alarm is on