User's Manual

CYCLING PROFILE
SETUP
Except wheel size setting, you could set up all for cycling profile following by the SETUP
section in RUNNING PROFILE, see page X.
NOTE Make sure bike pod sensor is paired with the watch before cycling.
The setup mainly includes the following parts:
 Lap (page )
 Interval (page )
 Rest (page )
 HR Zone (page )
 Wheel size (page )
Wheel size setup
1. In CYCLING mode, press top (1) button to enter, and the paired sensor icons display
on the screen. Press bottom (3) button to skip if the sensor is added.
2. Press middle (2) button to enter setup mode.
3. Toggle middle (2) button until adjust Wheel size displays.
4. Press top (1) button to enter.
5. Press top (1) button again to increase the value or press bottom (3) button to decrease
the value.
6. Press middle (2) button to confirm selection.
USEFUL REFERENCE
About Bike Wheel Size
Match the ETRTO or wheel size diameter printed on the wheel with the wheel size setting at
the right hand column of the table below. Input the relevant wheel size setting number after
bike pod is paired.
ETRTO
Wheel size diameter
(inches)
Wheel size setting
(mm)
25-559
26 x 1.0
1884