User's Manual

EN
10
• When the bike pod is paired successfully, the watch will
display
NOTE If pairing is weak and unstable:
• Shorten the distance between the device and watch.
• Re-adjust the position of the device.
• Check the batteries. Replace them when necessary.
NOTE If the watch is already paired with SZ909 chest belt,
and you want to pair with another chest belt, you have to
first remove the SZ909 chest belt before you are able to pair
with another chest belt. This principle also applies to bike
pod and foot pod.
INPUT BIKE WHEEL SIZE (FOR BIKE POD)
The watch will not show “WHEEL SIZE” if no bike pod is
paired. For details of bike wheel size, refer to “BIKE WHEEL
SIZE” section in this manual.
If your watch is paired with bike pod, you will be asked to
input the wheel size values.
1. Press MODE repeatedly to select .
2. Press
SET.
3. Press
ST/LAP/+ repeatedly to select “WHEEL SIZE”.
4. Press
SET.
5. Input the bike wheel size by pressing
ST/LAP/+ to
increase values or -/SP to decrease values.
6. Press
SET to confirm.
REMOVE PAIRED DEVICE
The watch will not show “DEVICE REMOVE” if no device
is paired.
1. Press
MODE repeatedly to select .
2. Press
SET.
3. Press
ST/LAP/+ repeatedly to select “DEVICE
REMOVE”.
4. Press
SET.
5. Press
ST/LAP/+ to select which device to delete.
6. Press
SET to confirm selection.
CALIBRATING PAIRED DEVICE
The watch will not show “CAL DEVICE” if no device is
paired.
You can calibrate by running, walking or inputting parameter.
The parameter is the same value after you have successfully