User's Manual

Even though there are areas that may have more

difficulty in receiving a signal, the atomic clock contains

accurate quartz movement and will retain precise timing

if the signal is missed on a rare occasion.

Reception can be affected by a number of

factors. For best reception, place the device away from

metal objects and electrical appliances. Other causes

for signal interference include electrical transmission

tower, steel reinforced construction, and metal siding.

Reception is ideal when placed near a window.

NOTE

TURN ATOMIC CLOCK ON / OFF

To manually enable the reception of the atomic clock:

Press and hold the UP button for 2 seconds until the

atomic clock reception symbol appears and flashes.

To manually disable the reception of the RF signal:

Press and hold the DOWN button for 2 seconds until

the atomic clock reception symbol disappears.

SETTING THE CLOCK MANUALLY

To adjust the clock settings manually without automatic

atomic clock synchronization, remember to disable the

atomic clock reception first.

To set the clock manually therefore:

1. Press and hold the DOWN button for 2 seconds

until the atomic clock reception signal disappears.

2. Press and hold the CLOCK button to enter the clock-

setting mode. Then use the UP or DOWN button to

adjust the value of each setting.

CLOCK MODE

The Clock mode has 3 types of display:

a) HH_MM_SS / Calendar

b) HH_MM_Day-of-the-Week / Calendar

c) HH-MM-ZONE OFFSET / Calendar

Press the CLOCK button to toggle between the

three modes.

CLOCK SETTING MODE

To set the time:

1. Press and hold the CLOCK button for more than

2 seconds.

2. Press the CLOCK button two more times. (Use the

UP and DOWN buttons to adjust the hour).

NOTE

RM818PA English R1 9/1/04, 11:20 AM8