User's Manual

ManualsBrandsIDT Technology ManualsElectronicsPluviometer with 433MHz Transmitter (433.92MHz Tx)

Wireless Rain Gauge

with Indoor / Outdoor Thermometer

Model: RGR126

User Manual

CONTENTS

Introduction ............................................................... 2

Product Overview ..................................................... 2

Front View .............................................................. 2

Back View............................................................... 3

LCD Display ........................................................... 3

Rain Gauge ............................................................ 4

Remote Thermo Sensor ......................................... 4

Getting Started .......................................................... 5

Main Unit ................................................................ 5

Rain Gauge ............................................................ 5

Thermo Sensor ...................................................... 6

Data Transmission ................................................. 7

Low Battery Warning ................................................ 8

Clock / Calendar Setting .......................................... 8

Set Clock and Calendar ......................................... 8

Rainfall ....................................................................... 8

Rainfall History ....................................................... 8

Total Rainfall ........................................................... 9

Rainfall Alarm ......................................................... 9

Temperature .............................................................. 9

Reset .......................................................................... 9

Precautions ............................................................... 9

Technical Specications ........................................ 11

About Oregon Scientic ........................................ 11

EU-Declaration of Conformity ............................... 12

FCC Statement ........................................................ 12

Declaration of Conformity ..................................... 13

Summary of content (13 pages)

PAGE 1
EN Wireless Rain Gauge with Indoor / Outdoor Thermometer Model: RGR126 User Manual Rainfall Alarm.......................................................... 9 Temperature............................................................... 9 Reset........................................................................... 9 Precautions................................................................ 9 Technical Specifications......................................... 11 About Oregon Scientific......................
PAGE 2
EN INTRODUCTION 1. Congratulations on purchasing the Oregon ScientificTM Wireless Rain Gauge with Indoor / Outdoor Thermometer (RGR126). FOUR-LINE LCD DISPLAY: For displaying the total rainfall, current rainfall or rainfall history, indoor / outdoor temperature and clock / calendar 2. SEARCH: Press and hold to enforce a search for the rain gauge and remote thermo sensor 3. in-mm:Selects between inch and millimeter rainfall measurement 4. ((.
PAGE 3
EN BACK VIEW 7. °C / °F button: Selects between °C and °F 8. Battery compartment LCD DISPLAY 1 2 3 4 1. ANTENNA: Receives radio signal from rain gauge and remote thermo sensor 2. : Increases setting values; press and hold for rapid increase 1. 3. : Decreases setting values; press and hold for rapid decrease Today’s Rainfall, Rainfall History, Rainfall Alarm, Start Date of Total Rainfall Record, Time / Date 2. Rain Gauge RF Reception Status, Total Rainfall 4. Wall mount hole 3.
PAGE 4
EN RAIN GAUGE Base and funnel: REMOTE THERMO SENSOR 1. 1 2 1 LED 3 1. Rain gauge 2. Battery compartment 3. RESET button 1 1 2 3 2 1. Funnel 2. Indicator 4 1. Wall mount hole 2. RESET hole 3. CHANNEL switch (1-3) 4.
PAGE 5
EN 2. GETTING STARTED Position the main unit, rain gauge, and thermo sensor within effective range: • Rain gauge - 100 meters / 328 feet • Thermo sensor - 100 meters / 328 feet IMPORTANT It is recommended that you follow the sequence below when setting up the units: NOTE Every time the battery in the main unit is changed, repeat installation before use. RAIN GAUGE 1. Set up the main unit. 2. Set up the rain gauge, then press and hold SEARCH on the main unit and wait until you receive a signal. 3.
PAGE 6
EN 1. Remove screws and slide the cover off in an upwards motion. 2. Insert the batteries (2 x UM-3 / AA), matching the polarities (+ / -). Press RESET after each battery change. Water will pool to the center of the cross when the rain gauge is level. If water remains on 1-4, the gauge is not horizontal. If necessary, adjust the level using the screw. 3 3. NOTE For best results, ensure the base is horizontal to allow maximum drainage of any collected rain.E Remove the fibre tape.
PAGE 7
EN 2. Set the channel switch to any channel. The switch is located in the battery compartment. 3. Press RESET on the sensor. 4. Close the remote sensor battery compartment. 5. Secure the sensor in the desired location using the wall mount or table stand. may affect battery performance and signal transmission. You may need to experiment with various locations to get the best results. Standard Alkaline batteries contain significant amounts of water.
PAGE 8
EN THERMO SENSOR RAIN GAUGE Replace the batteries immediately when the respective indicator lights up. DESCRIPTION Searching CLOCK / CALENDAR SETTING Connected Press TIME / SET to toggle among today’s rainfall, time, date, and year. Disconnected If without obvious reason the main unit display shows that the thermo sensor or rainfall connector is disconnected, press and hold SEARCH to enforce an immediate search.
PAGE 9
EN Use HISTORY to display the record for a particular day. The day of the record will be displayed with a minus (-) sign. The alarm will go off for one minute when the rainfall reaches the preset value and the rain alarm indicator will flash. A reminder beep will be emitted every minute. Once the rain alarm is on the indicator will not stop flashing unless is pressed or the rain alarm value is changed. To stop the alarm and reminder beep, press any button or change the rainfall alarm value.
PAGE 10
EN • • • • • • • • Placement of this product on wood surfaces with certain types of finishes, such as clear varnish, may result in damage to the finish. Consult the furniture manufacturer’s care instructions for direction as to the types of objects that may safely be placed on the wood surface. Oregon Scientific shall not be responsible for any damage to wood surfaces from contact with this product. Do not immerse the unit in water. Do not clean the unit with abrasive or corrosive materials.
PAGE 11
EN Power Main unit Rain gauge Remote thermo sensor General RF Transmission Frequency RF Transmission Range (unobstructed) TECHNICAL SPECIFICATIONS TYPE Main Unit Dimensions LxWxH DESCRIPTION 90 x 25 x 142 mm (3.54 x 0.98 x 5.59 inches) Weight (without battery) 173 g (6.1 oz) Main unit Display rainfall range (total) 0 - 25,400 (0 - 999.99 inch) Display rainfall range 0 - 2,540 mm (0 - 99.99 inch) (history / daily) Rainfall resolution 1 mm (0.
PAGE 12
EN EU-DECLARATION OF CONFORMITY FCC STATEMENT Hereby, Oregon Scientific, declares that this Wireless Rain Gauge with Indoor / Outdoor Thermometer (Model RGR126) is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This device complies with Part 15 of the FCC Rules.
PAGE 13
EN • • • Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio / TV technician for help. is in conformity with Part 15 of the FCC Rules.Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation.