User's Manual

TROUBLESHOOTING
This section includes a list of error messages and
frequently asked questions for problems you may
encounter with your blood pressure monitor. If the
product is not operating as you think it should,
check here before arranging for servicing.
Problem
Symptom
Check This
Remedy
No
power
Display is
dim or will
not light
up
Batteries are
exhausted
Replace
with new
batteries
Batteries
incorrectly
inserted
Reinsert
batteries
Low
batteries
Batteries low
Replace
with new
batteries
Error
message
Err 1
Data
transmission
failed
Move
closer and
Reattempt
to send
data
manually
LIg LOW
External
Measurement
Reminder
battery low
Replace
with new
batteries
SAFETY AND CARE INSTRUCTIONS
SAFETY PRECAUTIONS
Please observe the following safety precautions
when setting up and using your blood pressure
monitor.
• This device is intended for adult use only.
• This device is intended for non-invasive
measuring and monitoring of arterial blood
pressure. It is not intended for use on extremities
other than the wrist or for functions other than
obtaining a blood pressure measurement.
• Do not confuse self-monitoring with
self-diagnosis. This unit allows you to monitor
your blood pressure. Do not begin or end medical
treatment based solely on the measurements of
this device. Consult a physician for treatment
advice.
• If you are taking medication, consult your
physician to determine the most appropriate time
to measure your blood pressure. Never change a
prescribed medication without consulting your
physician.
• This unit is not suitable for continuous
monitoring during medical emergencies or
operations.
• If the cuff pressure exceeds 40 kPa (300
mmHg), the unit will automatically deflate. Should
the cuff not deflate when pressures exceeds 40
kPa (300mmHg), detach the cuff from the wrist
and press the button to stop inflation.
• To avoid measurement errors, carefully read
this manual before using the product.
CARING FOR YOUR BLOOD PRESSURE
MONITOR
To ensure you receive the maximum benefit from
using this product, please observe the following
care guidelines.
• When not in use, store the unit in a dry place
away from direct sunlight.
• Do not immerse the unit in water. If it comes in
contact with water, dry it immediately with a soft
lint-free cloth.
• Use a soft, slightly moistened cloth to wipe the
unit and cuff. Do not use abrasive or corrosive
cleaning agents, as these may cause damage.